Periodic Audio Neon Bluetooth Amp AptX AAC Low Latency High Power iPhone Android

Periodic Audio Neon Bluetooth 5.2 Amplified Receiver for Wired Headphones, Professional Condenser Microphone for phonecalls, AAC, AptX, Single Press Switch Between Two Sources • SPS Source Switching: Our exclusive SPS Single Press Switching means no more hassles un- pairing and re-pairing your most used sources. Connect to two different devices and hop between them with a single press of a button. Hop between your phone and laptop, or tablet and TV with a quick press. Neon improves your workflow and streaming audio experience. • "You Shall Pass!" - Gandalf: Neon's battery is certified by the Council of the Wise for the entire trilogy of The Lord of the Rings (Extended Edition) including side quests for porcelain respites and lembas bread breaks. Neon's 300 mAh battery is good for about 14 hours at normal listening levels with EN50332-compliant headphones. • Most mobile devices use the mediocre amps integrated into their multi-function chips. Neon uses a discrete amplifier architecture to deliver best-in-class sound quality. Neon's raw noise floor is below 105 nanovolts RMS at any frequency from 10 Hz to 20 kHz with less than 0.05% THD at normal listening levels. Neon also brings a massive 140 mW per channel into 32 Ohms to the table and can drive nearly any wired headphone out there to high dynamic levels. Specifications • Frequency Response: 13 Hz to 20 kHz +0 dB / - 3 dB • THD: < 0.05%, 20 Hz to 20 kHz @ 1 mW • SNR: 98 dB (noise floor less than 105 nVrms)