Invicta Flexible Band Tool W/ 2 Pins + 1 Watch Bracelet Holder (ITK004)

This universal kit allows you to size watches, switch out bracelets and straps and make minor repairs with ease! The band opener allows you to remove links from the watch band. Remove pins from your timepiece by using a pin tool and bracelet holder. How to Use One Watch Bracelet Holder: Use this to hold the bracelet in place while hammering out the pin to remove or add links for larger sized bands. On the underside of the bracelet links, there will typically be an arrow pointing in the direction the links should be pushed out. Position the pin pusher over the pin to be removed and tap the pin out from the top with the small hammer. Pins: This allows you to remove the band from the dial. Slip the tool between the band and the case where the spring bar is located. Then use this tool to unhook the spring bar thereby releasing the band. The Invicta Tool kit is intended to assist you with opening and potentially repairing your watch, when used properly as intended. Please note, however, that the limited warranty that may be applicable for your watch is only valid when the watch is evaluated and handled by Invicta’s official and authorized watch repair center. If you choose to use the Invicta Flexible Band Tool W/ 2 Pins + 1 Watch Bracelet Holder on your own, this will automatically void any and all warranties, as applicable.